Club Rules

Last revised December 2017

To download a PDF with the club rules please click on the link below. 

CMAC Safety and Operating Guide 2017 V1.0

1.0 General

1.1 The Cronulla Model Aero Club (CMAC) is principally a social and training club.
1.2 This Safety Information and Operating Etiquette (the rules) is in place to ensure that
members and visitors can enjoy the pursuit or observation of aero-modelling activities
in a safe and friendly environment.
1.3 All members shall be familiar with the safety requirements and appropriate actions in
any situation that may rise during operations that could result in an adverse, unsafe or
inappropriate situation.
1.4 All new members shall at the time of joining, be given a full induction on safety
requirements and operating etiquette, whilst non-flying visitors will be escorted by a club executive.
1.5 Any financial member of the club is permitted to seek amendment to the rules. Such
amendments will be considered by the Standing Club Executive Committee.
1.6 The Cronulla Model Aero Club is predominantly a club for powered fixed-wing aircraft.
Rotary wing (ie Helicopters) and FPV should fly off the rotary wing site adjacent to the car park.
1.7 The flying of specialist type models such as Gas-Turbine (Jets), Pylon Racers and/or Giant Scale may only be undertaken with the endorsement of the Chief Flying Instructor, Club Flying Instructor or approved model inspector who will ensure that the appropriate permits and certification certificates are held for the model by the pilot in command. This is a once off requirement.
1.8 However, as with all model types operated at the Field, the Chief Flying Instructor, Club Flying Instructors or the Executive Committee may elect to restrict the use of a particular model at any time on the basis of noise or safety risk.
1.9 When we have public visitors present then startup of Gas Turbines is to be done on the runway to ensure safe distance is maintained from the spectator area.
1.8 All pilots of model aircraft shall be familiar with, and understand their obligations with
regard to the Australian Civil Aviation Safety Regulations; In particular, Part 101, section G, of the 1998 Regulations and the Model Aeronautics Association of Australia – Manual of Procedures for model aircraft.
l1.9 Only persons with a minimum of Bronze wings pilot accreditation shall be permitted to fly solo (ie without secondary observation and guidance). All other persons must be under the direction of an Approved Flying Instructor or his/her nominated delegate. Such delegates should be the holder of a gold wings accreditation or be of equal standard.
1.10 All safety related incidents & accidents, and/or frequency interruptions must be reported to a committee member or the Chief Flying Instructor.
1.11 Flying under the influence of drugs or alcohol is strictly forbidden.

2. Transmitter Use (all frequencies)

2.1 For all aircraft, where the radio / receiver supported it, the failsafe should be set to close the throttle on loss of radio signal. Any model that will go to an open throttle on loss of radio (switching off the transmitter while still armed) is not permitted at any time.
Non-2.4 gig Transmitter Use
2.2 All non-2.4 GHz Transmitters shall be placed in the transmitter compound when not in use.
2.3 All members using non-2.4 GHz shall make use of a standard (Silverstone type) transmitter frequency key. Each key shall identify the name of the member or flying visitor, the operating
frequency and the pilots mobile phone number.
2.4 Any transmitter non-2.4 GHz shall not be turned on, nor have the antenna raised
until the appropriate key has been placed on the frequency board.
2.5 If two or more operators are sharing a frequency, each pilot shall limit the use of the frequency to 15 minutes.
2.6 Pilots must remove their frequency key from the board immediately upon landing,
securing their aircraft and switching the transmitter off.
2.7 If a pilot has a crash or needs to recover his/her aircraft, the pilot must first switch off
their transmitter and leave it in the transmitter compound before retrieving the aircraft. In the case of electric aircraft, it may be a requirement to leave the transmitter switched “on” until the aircraft is located and batteries disconnected to isolate the motor.
3. Start up and taxiing
3.1 Pilots must carefully and effectively restrain aircraft during startup operations. This may
be via a device fixed to the ground (ie wing or tail chocks) or a bench with appropriate
wing poles or wheel bars. The use of flight or tool boxes placed in front of wings or
tail planes is not considered as appropriate restraint. The exception to this is flight boxes
that have raised aircraft support stands.
3.2 Propeller wash shall be directed away from other persons.
3.3 Where engine tuning requires that the aircraft be held vertically, it must be done whilst
standing with the propeller well above the operator’s head. Placing the aircraft into a
vertical position must not be done whilst in the kneeling position.
3.4 Extended engine running must not be carried out in the pit area or on the flight line. A
maximum time or 2-3 minutes is acceptable. “Run up” bays that are positioned away
from general pits or social gathering areas shall be used for extended engine runs.
3.5 Aircraft shall not be taxied in the pits area. Inbound aircraft must have engines stopped
before passing into the pits area.
3.6 When walking from the starting tables to the flight line, Pilots must take all care to ensure they keep a safe distance from any person in the pits area and take extreme care not to accidently bump open the throttle. The use of throttle hold switches is highly recommended. Or seek assistance from other members to carry your transmitter or model, particularly if you have mobility problems.
3.7 Electric models are to be armed and disarmed on arriving and leaving the flight line using the arming tables providing. Exceptions will be make for electric models where arming / disabling at the flight line is not practical or safe providing such models are set up with arming switches on the model and / or radio that prevents the motor starting up if the throttle stick is bumped.

4. At the flight line.

4.1 The maximum flying height for model aircraft is 400 feet Above Ground Level.
4.2 No more than six (6) aircraft shall be permitted in the air at any one time.
4.3 Pilots on the flight line shall move left or right subject to the direction of the circuit to
make room for pilots joining the flight line.
4.4 All pilots shall be familiar with the taxiway entry, exit and holding points for the runway.
4.5 Prior to runway entry or takeoff, pilots shall make a “clear for takeoff” call and seek acknowledgement of clearance before aircraft are permitted to taxi to the takeoff position.
4.6 All circuits and general flying must be carried out in front of the pilot. Flying overhead,
behind the flight line, above the pits, over or beyond Heathcote Road is not permitted at
any time. Please refer to the No Fly Zone map on the notice board.
4.7 Flying counter to the nominated circuit is prohibited.
4.8 When there is a wind direction change that requires a change of circuit direction, all
pilots must be informed of the circuit direction change.
4.9 When a pilot wishes to land, he/she must call “downwind for landing, or “landing” and step forward
to the fence barrier” and the position of the aircraft shall be opposite or slightly past the flight line about to turn onto the base leg. This call may be abbreviated to “landing” if there is a need to clarify the intent to land (eg on final approach)
4.10 Where a landing is aborted, the pilot shall make the call “going around”
4.11 Where a pilot experiences an engine failure the pilot shall call out “Dead stick” to alert all other pilots on the flight line and persons wishing to cross the runway of the impending situation. The pilot has immediate right of way for runway use.
4.12 Persons seeking to enter or cross the runway whilst aircraft are operating shall do so by
calling “on the Strip” or “crossing the strip” and may only do so when it is visibly safe to
do so.

5. Flight times.

5.1 Flying is permitted between 0800 (8 am) and sundown – 7 days a week.
5.2 Electric powered aircraft are permitted to operate from sunrise, providing they are quiet.
5.3 Night flying is not permitted
5.4 On Saturday mornings before 10:00 am, general flying may be restricted to allow for training of new pilots under instruction from club instructors.

6. Vehicle in the pits area.

6.1 Vehicles may enter the pits area for loading or unloading aircraft.
6.2 At peak times, (ie Sat & Sun) vehicles shall be removed from the area once unloading or
loading is completed.
6.3 Drivers are reminded to extend a courtesy to other members whilst parked in the pits
area regarding obstruction of thoroughfares or walkways.
6.4 Persons who arrive after 0930 are encouraged to park in the car park and carry their
aircraft and associated equipment into the pits area.

7. Benches / tables

7.1 Benches may be reserved for the exclusive use of a member, providing that there is clear signage attached to such benches so that all other members are aware of the reservation. This reservation should include your name and your regular flying days so that other members may use the bench at other times. All bench reservations are to be approved by the committee in advance.
7.2 Any benches not marked as reserved as per 7.1 are free to be used on a first come, first served basis.
Any reserved bench that is not in use by 9:30 am is also available to other members. If you need to use a particular bench and another member is already using it you may politely ask whether the current user of the bench is able to relocate to another bench.
7.3 Should a member with a reserved bench knowingly be absent from the field for a period, he/she should make it known to other members and allow their bench to be used.
7.4 New members seeking to establish their own bench should consult with a member of
the committee who will provide guidance on the process.
7.5 Members and flying visitors who do not require the use of a bench or table must consider their set up location. Due to the size of some models, specific large model set up areas have been permanently designated.

8. Searching for lost models

8.1 Should you be required to search for a “lost” or “downed” aircraft, ensure another club
member is aware of the general search direction you are heading and a frequency key
shall be placed in the aircraft search panel. The key should be endorsed with your
mobile phone number. It is preferable for safety reasons that searching for models be
undertaken in pairs.
8.2 Always have a mobile phone with you when going into the bush. It’s also advisable to carry some drinking water, particularly in hot weather.

9.0 General courtesies and etiquette.

9.1 All members have an obligation to ensure that a safe operation is maintained always. Everyone is a safety officer as we are all responsible for our own safety and those around us. Speak up if you see a dangerous situation.
9.2 Younger members shall always extend their help to senior members who may require
assistance with movement of their aircraft or should the need arise, when conducting a
9.3 The setup, maintenance and lockup of the facilities shall be shared by all members. This
includes deployment or removal of windsocks and frequency key boards, assistance with
Tea & Coffee supplies, opening and closing of access gates and attendance at organised
working bees as required from time to time.
9.4 All members are prohibited from removing, trimming or clearing any live vegetation, unless under the instruction of the committee at designated working bee days.
9.5 No smoking is permitted in the pits area or flight line at any time.
9.6 Please remember that all social media is public and should not be used to discuss Club business, safety issues or security. These sites are for sharing news, photos, videos and stories. Please always be polite, no swearing and no politics. We want these sites to be fun and enjoyable for all members. This is not the place to gripe about things. That’s what the committee members are for 😊.
9.7 Please make a gold coin donation if you make use of the Coffee and Tea supplied. Your donation helps pay for the cost of providing this.

10.0 Gates and Security

10.1 The first member to arrive (with keys) should unlock all the gates and bring the padlocks from the 1st(Road) and 2nd (Carpark) gates into the shelter area and place the padlocks in the designated area in the open (unlocked) position. The padlock of the 3rd gate (Pits) can be left in the gate open (unlocked).
Please set the gate sign to say the field is open.
10.2 The last member to leave the field each day is required to ensure that the windsock is put away under the shelter table trays and the trays under the table are closed and the tool used returned to the usual hiding spot.
Check that the fire is out (if used) and ensure all three gates are closed, latched and padlocks are closed (locked). Please set the gate sign to say the field is closed.
10.3 If you are visiting the club at time or day where only a few members are present, it’s advisable to keep the 1st and 2nd gates closed and locked to avoid any unwanted trespassers.
10.4 Flying at the field with no other members present is strongly discouraged. It’s important to have a friend present in case of an emergency or injury.
10.5 Please be aware that due to remote location of the field any police or ambulance response will be slow so please be aware of your personal situation and avoid any unnecessary risks.
10.6 Holders of gate keys shall not copy or lend their key to other persons. A gate key will only be issued to a person at the discretion of the club committee and after a period of financial membership for 12 months or greater.